/**
 * micro:bit + Dataflow: "Mock Communicator"
 * 
 * This is a program for the micro:bit physically attached to the computer, used for development on the dataflow side. 
 * This is designed to mock output from the communicator micro:bit in a world of radio networked sensor/actuator hubs
 *  
 * [ A ] - mode 1 - "on" : pass a stream of mock messages to serial (dataflow)
 * 
 *  (name: sat, value: 20.4)      sat20.2       "the temperature reading on microbit A is 20.2 degrees"
 *  (name: sbt, value: 17.32)     sbt17.32      "the temperature reading on microbit B is 17.32 degrees"
 *  (name: sah, value: 40)        sah40         "the humidity reading on microbit A is 40 percent"
 *  (name: sar2, value: 1)        sar21         "the state of microbit A's relay 2 is on"
 *  (name: sar2, value: 0)        sar20         "the state of microbit A's relay 2 is off"
 * 
 * [ B ] - mode 0 - "off": dont' send any mock messages
 */

let mode = 0
let mIndex = 0

function turnOn() {
    mode = 1
    basic.showIcon(IconNames.Happy)
}

function turnOff() {
    mode = 0
    basic.showIcon(IconNames.Asleep)
}

let messageObjects = [
    { name: "sat", value: 10.4 },  // temp a rises
    { name: "sat", value: 10.5 },
    { name: "sat", value: 10.6 },
    { name: "sbt", value: 11.32 }, // temb b falls
    { name: "sbt", value: 11.22 },
    { name: "sbt", value: 11.12 },
    { name: "sah", value: 40 },
    { name: "sah", value: 20 },
    { name: "sah", value: 10 },
    { name: "sar2", value: 1 },  // relay A2 on, then off
    { name: "sar2", value: 0 },  
    { name: "sar1", value: 0 },  // relay A1 off, then on
    { name: "sbr1", value: 1 }
]

function startUp() {
    serial.redirect(
        SerialPin.USB_TX,
        SerialPin.USB_RX,
        BaudRate.BaudRate9600
    )
    mode = 0
    mIndex = 0
    basic.showIcon(IconNames.Asleep)
}

function nextIndex(){
    mIndex = mIndex + 1;
    if (mIndex > messageObjects.length - 1) {
        mIndex = 0
    }
}

function sendStreamMessage(name: string, value: number) {
    if (mode == 1) {
        // send with :
        // serial.writeValue(name, value)
        
        // send without :
        serial.writeLine(`${name}${value}`)
    }
}

startUp()

input.onButtonPressed(Button.A, function () { turnOn() })
input.onButtonPressed(Button.B, function () { turnOff() })

basic.forever(function () { 
    if (mode == 1) {
        nextIndex()
        for (let i = 0; i < 10; i++) {
            sendStreamMessage(messageObjects[mIndex].name, messageObjects[mIndex].value)
        }
        
    } else {
        basic.showIcon(IconNames.Asleep)
    }
})